(Merc, Mariner, OMC, etc.) ELECTRONIC TACHOMETER. Model LM10000 All
Colors. In-dash Installation Instructions. FOR USE ON STANDARD AND MOST ...
ELECTRONIC TACHOMETER Model LM10000 All Colors In-dash Installation Instructions FOR USE ON STANDARD AND MOST ELECTRONIC IGNITIONS
IMPORTANT: This tachometer has a new improved meter. The tach pointer may not always reset at zero. This is normal. When the engine is started, pointer will position itself on the correct RPM. THIS INSTRUMENT MUST BE INSTALLED BY A COMPETENT MARINE MECHANIC. This tachometer is factory calibrated to operate on a V6 outboard engine that produces 12 pole/6 pulse per revolution. (Merc, Mariner, OMC, etc.)
MOUNTING 1. Cut a 4 5/8” diameter hole in the dashboard for the tachometer. 2. Connect the tachometer wires as shown below. 3. Secure the tachometer in the dashboard using the brackets, lockwashers and nuts provided.
WIRING 12 VOL T BATTE RY
12 VOLT IGNITION SWITCH (+)
RED
CK
Use Tach Terminal on electronic ignitions. If available (MSD & GMHEI). If tach Terminal is not available, use coil negative (-).
BLA
GINE
D EN GOO OUND GR
BLACK
OR
GREEN
GREEN WHITE
GREEN
On standard ignitions, GREEN wire 12 VOLT attaches to coil DASH LIGHTING (+) negative (-). IGNITION COIL
ELECTRONIC IGNITION
WARNING WARRANTY will be void if connected to coil on MSD ignitions.
NOTE:
This tachometer operated on standard, factory electronic and high-performance electronic racing ignitions, such as Laser II, Hy Fire and MSD. This tachometer is NOT recommended for use on Accel BEI or Laser I ignitions.
10 Livorsi Drive, Grayslake, Illinois LM10000.QXD
*
847-548-5900
*
Fax 847-548-5903
www.livorsi.com *
[email protected]