DME Removal, 03-> Porsche Cayenne - AWE Tuning

51 downloads 3261 Views 222KB Size Report
Step 1. Pop the hood. The DME (engine control unit) is located under the pas- senger side of the black plastic trim that runs along the lower edge of the ...
DME Removal, 03-> Porsche Cayenne Tools Required:

Estimated time:

None

10 minutes

Step 1 Pop the hood. The DME (engine control unit) is located under the passenger side of the black plastic trim that runs along the lower edge of the windshield.

Figure Figure 11 Step 2 Carefully peel up the passenger side of the black plastic trim.

Figure 22 Figure Step 3 Remove the DME by releasing the plastic clip holding it onto the firewall of the vehicle.

Figure 3 Step 4 With the key out of the ignition switch, disconnect the wiring harnesses from the DME. Pull the “T” shaped handles at the end of each connector away from each other, in the direction of the arrow in Figure 4. It does not matter which connector you release first. Reinstallation is the reverse of removal. Figure Figure 44 Any questions, please contact us: 215-658-1670 1-888-565-2257 [email protected]