Manual. How to Programme your remote control. BENINCA T2WK – T4WK. • How
to program your new remote control: From a remote control that has already ...
Manual How to Programme your remote control BENINCA T2WK – T4WK
•
How to program your new remote control:
From a remote control that has already been programmed: 1- Approach your motor so you are standing a few feet away from it. 2- Press a button on your new remote control. Keep it pressed down. Wait 5 seconds. The LED light on your new remote control blinks. Let the button go. 3- Place an already-programmed remote control (T1) next to the new remote control (T2) so they touch as shown in the diagram above. If the remote control that has already been programmed is an older model, place them together as shown in figures 1 or 3. If it is a newer model, use figure 2. 4- Press the same button on your new remote control as the button that has already been programmed on your old remote until the LED light of your new remote control turns off. 5- Repeat this procedure for each button you wish to program. 6- Wait 10 seconds. 7- Your new remote control is programmed.