PROGRAMMING WITH AD CARD - Bunn

29 downloads 601 Views 140KB Size Report
Page 10. PROGRAMMING WITH AD CARD. Using an AD CARD to load ADS: The information is loaded into the brewer's memory by holding the chip area up to ...
PROGRAMMING WITH AD CARD NOT AVAILABLE ON ITB Using an AD CARD to load ADS: The information is loaded into the brewer’s memory by holding the chip area up to the brewer’s SENSING COIL. NOTE: Instructions to program the brewer are printed on the AD CARD. Procedure to program the AD: 1. Remove the funnel(s) if present. 2. Position the RECIPE CARD vertically, so that the top end of the CHIP is beneath the (Left on Twins) SENSING COIL (located on the underneath side of the front display panel). 3. After a short pause the display will read CARD CONTAIN ADS/SHOW-QUIT-SAVE. 4. To show (view) this information, select "SHOW". The display will scroll through all of the ad on that chip. The display will then return to CARD CONTAIN ADS/SHOW-QUIT-SAVE. 5. If message is correct, press SAVE. The display will read AD MESSSAGE SETUP COMPLETE. The ad is now stored in the brewer’s memory. 6. If the ad is not correct, or it is desired to exit the setup before the ad is loaded into the brewer’s memory, press QUIT. The display will then return to the MAIN SCREEN.

READY TO BREW WATER TEMP XXX° POSITION CARD UNDER SENSOR COIL

CARD CONTAIN ADS SHOW QUIT SAVE

SCROLLS THROUGH COMPLETE MESSAGE

AD MESSAGE SETUP COMPLETE

READY TO BREW WATER TEMP 200°

NOTE: ENABLE ADS must be turned on in LEVEL 2 in order for the newly programmed ad message to be displayed.

Page 10

41581.2 091609

Suggest Documents