RAMP-1-1000M-32d-Sf-4W-e7 - Raditek

RADITEK

INC.

code-e7

High Power Linear Amplifier, Ultra Broadband 1-1000MHz, 32dB Gain, SMA Female Connectors, 4 Watts

RAMP-1-1000M-32d-Sf-4W-e7 This amplifier module utilizes MOSFET power devices that provide high gain, wide dynamic range and good linearity. Exceptional performance is achieved by employing advanced broadband RF matching networks and combining techniques, EMI/RFI filters, machined housings and qualified components.. ►Solid-state Class AB linear design. ►Instantaneous ultra broadband. ►Compact and lightweight. ►M&C Monitor and Control. ►Suitable for most modulation types. ►50 ohm input and output impedance. ►Highly rugged and reliable. ELECTRICAL SPECIFICATIONS @ +28 VDC, 25°C, 50 Ω System Parameter Symbol Operating Frequency BW Power Output CW PSAT Power Output @ 1 dB Gain Compression Point P1dB Gain @ P1 dB Gain Compression Point G1dB Input Power for Rated Pout PIN Small Signal Gain Flatness ΔG VVA Adjustment Range VVA Input Return Loss S11 Noise Figure NF Harmonics @ rated P1 dB Gain Compression H Point Third Order Intercept Point 2-tones, POUT =26 IP3 dBm/tone, Δ = 100 KHz Spurious Signals Spur Operating Voltage VDC Quiescent Current IDQ Current Consumption @ rated POUT IDD ENVIRONMENTAL CHARACTERISTICS Parameter Operating Case Temperature Storage Temperature Relative humidity (non-condensing) Altitude (MIL-STD-810F Method 500.4) Shock / Vibration (MIL-STD-810F Method 516.5) MECHANICAL SPECIFICATIONS Parameter Dimensions (excluding heatsink) Weight without HS / with HS RF Connectors In/Out DC / Interface Connector Cooling

RAMP-1-1000M-32d-Sf-4W-e7

Symbol Tc Tstg RH ALT SH / VI

Min 1 4 3 32

Typ

Max 1000

5

4 ±1.0 25 -10 10

7

26

Min 0 -40

Units MHz Watt Watt dB dBm dB dB dB dB

-25

dBc

+43

dBm

-70 28 1.0

Typ

10,000

-60 30 1.5

dBc Volt Amp Amp

Max +75 +85 95 30,000

Units °C °C % Feet

Airborne

Value 3.5 x 2.5 x 1.1 1.0 / 2.5 SMA female Dsub, 9-Pins, Male External Heatsink

Units Inch (max) lb. (max)

Specifications may be subject to change

WORLD HQ: 1702L Meridian Ave. Suite 127, San Jose, Ca 95125, U.S.A. Tel: (408) 266-7404 FAX: (408) 266-4483 WEB: www.raditek.com E-mail: [email protected] 1 of 3

06/27/11

RADITEK

INC.

code-e7


RAMP-1-1000M-32d-Sf-4W-e7 PROTECTIONS Parameter Input Overdrive Load VSWR Thermal Overload

Value +10 ∞ @ all load phase & amplitude 85°C shutdown

INTERFACE CONNECTOR – D-Sub, 9-Pin Pin # Description 1 N/C 2 N/C 3 Temperature Sense 4

VVA

5 6 7

Shutdown VDD VDD

Units dBm Max Nom Max

Specifications Reserved Reserved Analog voltage relative to Module’s Temperature @ 10 mV/°C Continuous Analog 0 – 5 VDC levels Maximum Gain: 0 VDC Minimum Gain: 5 VDC Amplifier Enable: TTL “Low” or Open Amplifier Disable: TTL “High” (Default) +28 V ±2 VDC +28 V ±2 VDC Adequate Heat Sink Required OUTLINE DRAWING

RADITEK RAMP-1-1000M-32dSf-4W-e7

Units: Inch Not to scale




06/27/11

RADITEK

INC.

code-e7


RAMP-1-1000M-32d-Sf-4W-e7 Plots 1 - Small Signal and P1dB Gain Top Curve: Small Signal Gain @ PIN = -20dBm Middle Curve: Power Gain @ P1dB, PIN = 2.0dBm Reference: 32dB, 1dB/div. Bottom Curve: Input Return Loss Reference: 0dB, 10dB/div.

Plot 2 - Small Signal and PSAT Top Curve: Small Signal Gain @ PIN = -20dBm Middle Curve: PSAT @ PIN = +4.0dBm Reference: 32dB, 1dB/div. Bottom Curve: Input Return Loss Reference: 0dB, 10dB/div.

Plot 3 - VVA Adjustment Range Top Curve: Max. Gain @ VVA = 0.0V, PIN = -20dBm Middle Curve: Max. Gain @ VVA = 5.0V Reference: 0.0dB, 10dB/div. Bottom Curve: Input Return Loss Reference: 0dB, 10dB/div.




06/27/11