Wordpress Plugin Setup Guide - Marketo LaunchPoint

6 downloads 79 Views 496KB Size Report
Wordpress Plugin - Lite. Setup Guide. Version ... Section I. Plugin Installation . ... Install a Plugin using Upload Method in WordPress Admin Panel. 1. First you ...
Wordpress Plugin - Lite Setup Guide Version 1.0

©Hoosh Marketing, Private and Confidential

Contents

Section 0. Pre Setup ...................................................................................................... 3 Section I. Plugin Installation ......................................................................................... 3 Section II. Configure Plugin .......................................................................................... 4 Section III. Enable the Munchkin Code ......................................................................... 4 Section IV. Save Settings .............................................................................................. 4

©Hoosh Marketing, Private and Confidential

Page 2

Section 0. Pre Setup ALWAYS remember to make a full db/file backup before installing any new plugins!

Section I. Plugin Installation Install a Plugin using Upload Method in WordPress Admin Panel 1. First you would need to download the plugin from the source (which will be a zip file), then go to your WordPress admin panel. Click on Plugin » Add New. Then click on the Upload Tab.

You will see a screen like the one above. Browse the file and upload it (zip files only). You will be taken to the activate a plugin page just like this one:

Make sure that you click on Activate the plugin, now you have installed the WordPress plugin. You would have to configure the settings to fit your needs. These settings will vary for each plugin therefore we will not be covering that in this post.

©Hoosh Marketing, Private and Confidential

Page 3

Section II. Configure Plugin 1. Go to WP Admin ->Marketo Connector

2. Fill in the details as per your Marketo instance. Note you may not see all these fields depending you the version of your plugin.

Section III. Enable the Munchkin Code 1. Go to Embed Munchkin Code 2. Select from the drop down the munchkin type you require. If you don’t know which one to select pick ‘Simple’

Section IV. Save Settings 1. Click the ‘Save’ button to save the configuration changes 2. You may need to clear the cache if you are using any caching plugins like W3 Total Cache

©Hoosh Marketing, Private and Confidential

Page 4

Suggest Documents