Int J Adv Manuf Technol (2007) 33:719 DOI 10.1007/s00170-006-0877-8
ERRATUM
Decision support tool for selecting fabrication parameters in stereolithography J. Giannatsis & V. Dedoussis
Published online: 20 December 2006 # Springer-Verlag London Limited 2006
The originally published reference list of this article unfortunately contained a mistake. Incorrect reference: 17. Yew AB, Kai CC, Zhaohui D (2000) Development of an advisory system for trapped material in rapid prototyping parts. Int J Adv Manuf Tech 16(10):733–738 Correct reference: 17. Ang BY, Chua CK, Du ZH (2000) Development of an advisory system for trapped material in rapid prototyping parts. Int J Adv Manuf Tech 16(10):733–738
The online version of the original article can be found at: http://dx.doi. org/10.1007/s00170-006-0496-4. J. Giannatsis : V. Dedoussis (*) Center for Product Development and Rapid Prototyping, Department of Industrial Management and Technology, University of Piraeus, 80 Karaoli & Dimitriou Str., 18534 Piraeus, Greece e-mail:
[email protected] J. Giannatsis e-mail:
[email protected]
