Jun 12, 2002 ... Errata for. VIDEO PROCESSING AND COMMUNICATIONS. Yao Wang, Joern
Ostermann, and Ya-Qin Zhang. (©2002 by Prentice-Hall, ISBN ...
Errata for VIDEO PROCESSING AND COMMUNICATIONS Yao Wang, Joern Ostermann, and Ya-Qin Zhang (©2002 by Prentice-Hall, ISBN 0-13-017547-1) Updated 6/12/2002
Symbols Used Ti = i-th line from top; Bi = i-th line from bottom; Fi = Figure i, TAi = Table i, Pi=Problem i,E(i)=Equation(i), X -> Y = replace X with Y
Page Line/Fig/Tab Corrections 16
F1.5
48
B6, E(2.4.4)E(2.4.6) E(5.2.7) F5.11 T7 B10 B4 B2 Before E(5.5.13) P5.3
119 125 126 133
138
P5.4 143
T4
159 189 190
T6 P6.1 P6.12
199
T9
200 214
B8 P7.5
218 247
P7.6 F8.1 F8.9
Add an output from the demultiplexing box to a microphone at the bottom of the figure. Replace “v_x”, “v_y” by “\tilde v_x”, “\tilde v_y” C(X)->C(X,t),r(X)->r(X,t),E(N)->E(N,t) Caption: “cameras”-> “a camera”, “diffuse”-> “ambient” “diffuse illumination”-> “ambient illumination” T_x,T_y,T_z -> T_x,T_y,T_z, and Z Delete “when there is no translational motion in the Z direction, or” “aX+bY+cZ=1” -> “Z=aX+bY+c” Add “(see Problem 5.3)” after “before and after the motion” “a planar patch” -> “any 3-D object”, “projective mapping”->Equation (5.5.13)” “Equation 5.5.14”-> “Equation (5.5.14)”, “aX+bY+cZ=1”-> “Z= aX+bY+c” After “true 2-D motion.” Add “Optical flow depends on not only 2-D motion, but also illumination and object surface texture.” After “block size is 16x16” add “, and the search range is 16x16” “global”->”global-based” Add at the end “Choose two frames that have sufficient motion in between, so that it is easier to observe the effect of motion estimation inaccuracy. If necessary, choose frames that are not immediate neighbors.” “Equation (7.1.11) defines a linear dependency … straight line.” -> “Equation (7.1.11) says that the possible positions x’of a point x after motion lie on a straight line. The actual position depends on the Zcoordinate of the original 3-D point.” “[A]” -> “[A]^T [A]” “Derive”-> “Equation (7.1.5) describes” Add at the end “(assuming F=1)” Replace “\delta” with “\bf \delta” “Parameter statistics” -> “Model parameter statistics” Add a box with words “Update previous distortion \\ D_0=D_1” in the line with the word “No”.
255 261
F8.14 P8.13(a)
416 421 436 443 575
TA13.2 TA13.3 T13 T10 P1.3 P1.4
Same as for F8.9 “B_l={f_k, k=1,2,… ,K_l}” -> “B_l, which consists of K_l vectors in {\cal F}” Item “4CIF/H.263” should be “Opt.” Item “Video/Non-QoS LAN” should be “H.261/3” “MPEG-2, defined” -> “MPEG-2 defined” “I-VOP”->”I-VOPs”, “B-VOP”-> “B-VOPs” “red+green=blue”-> “red+green=black” “(1.4.4)” -> “(1.4.3)”, “(1.4.2)” -> “(1.4.1)”
