Installation Manual SATA to IDE Adaptor - Syba

138 downloads 614 Views 87KB Size Report
MANL-ADSAIDE-S1-EN-200905. Installation Manual. SATA to IDE Adaptor. ADSAIDE-S1. ADSAKIT-V1. ADSAKIT-V2. All contents and specification mentioned ...
MANL-ADSAIDE-S1-EN-200905

Installation Manual SATA to IDE Adaptor

ADSAIDE-S1 ADSAKIT-V1 ADSAKIT-V2

All contents and specification mentioned in this manual are subject to change without prior notice All brand names and tradenames referenced and mentioned in this manual are property of their respective owners.

Introduction This SATA to IDE adaptor is designed to provide an easy solution for D.I.Y users for connecting any existing 3.5” IDE hard drives or 5.25” ATA / ATAPI devices to the new Serial ATA bus, an ideal interconnect device for multimedia application. This SATA to IDE adaptor is compliant with Serial ATA (Generation 1) Specification with peak data transfer rate up to 1.5Gb/s (150MB/s) on the SATA side and is compatible with Ultra ATA133 on the PATA side.

General Features •

Standalone Parallel ATA (PATA) to Serial ATA (SATA) device bridge chipset



Compliant with ATA/ATAPI-6 Specification



Compatible with Ultra ATA133



Compliant with Serial ATA Specification Revision 1.0



Support peak data transfer rate up to 1.5Gb/s (150MB/s)



Support Hot-Swap and Wake-Up



Accommodate all existing 3.5” IDE hard drives or 5.25” ATA / ATAPI devices



Driverless – No driver required

What is in your package? Please check whether the package contains following items: ITEMS SATA to IDE Adaptor Unit Installation Manual SATA Cable DC12V to FDD / HDD Power Adaptor DC12V Power Supply

ADSAIDE-S1

MODEL NO. ADSAKIT-V1

ADSAKIT-V2

9 9 8 8 8

9 9 9 9 8

9 9 9 9 9

If any item is missing or damaged, please contact the retailer as soon as possible.

HARDWARE INSTALLATION Installation Tips •

For all existing 3.5” hard drives and 5.25” ATA / ATAPI devices, please make sure the jumper setting on the device is set to “Master” mode before connecting the SATA to IDE adaptor to the device. Do not set the jumper to “Slave” or “Cable Select” mode.



Make sure to format your hard drive before connecting to the adaptor. Under certain circumstances, your operating system may not be able to detect unformatted hard drive through this adaptor.

1

WARNING •

If there is data stored in your hard drive, please make sure to backup all your existing data from hard drive before connecting the adaptor to the hard drive. Manufacturer is not responsible for data loss due to abuse, misuse, or neglect. Should you have any installation problem, please contact your dealer for assistance.

How to install the adaptor?

Connecting to a 3.5” Hard Drive

Connecting to a 5.25” ATA / ATAPI device Step 1.

Align the SATA to IDE adaptor’s IDE connector to the IDE device’s interface and gently push it in.

Step 2.

Connect one end of the SATA cable to the SATA to IDE adaptor and the other end to the computer.

Step 3.

If you have purchased the kit set, connect the DC12V to FDD / HDD power adaptor to the SATA to IDE adaptor and the IDE device. If you did not, you need to find another power source to connect the SATA to IDE adaptor and the IDE device.

Step 4.

Finally, if your kit set come with a DC12V power supply, connect it to the DC12V to FDD / HDD power adaptor.

SOFTWARE INSTALLATION Driverless – No driver required!

2