Programming Manual http://www.remotecontrol-express.com - TEL : +44 (0) 207
399 7782 - FAX : +44 (0) 207 927 3151. PROTECO TX3. Programming of your ...
Programming Manual PROTECO TX3
Programming of your new remote control: 1. 2. 3. 4. 5. 6. 7. 8.
Approach the casing of your receiver (diagram above). It is located next to your motor. Press button A several times until the digital screen displays « rA » Press button B several times until the digital screen displays « Tc » Press a button on your new remote control. Keep it pressed down. A point appears on the digital screen between « T » et « c ». While keeping the button on your new remote control pressed down, press the button C. The digital screen displays « 01 ». Let the buttons go. Press button A several times until the digital screen displays « -- ». Wait 10 seconds. Your new remote control is programmed.
