Toyota Tacoma 2005-2011

sPOD Installation Instructions 2005 – 2011 Toyota Tacoma www.4x4s-POD.com

2. Mount the bracket to the inside fender-well where shown on drivers side next to brake booster. Use supplied selfdrilling screws and washers.

3. Feed white connector Push white connector through steering column grommet

Run white connector up through opening in plastic

Plug connector in with key facing outward

1

sPOD Installation Instructions 2005 – 2011 Toyota Tacoma www.4x4s-POD.com

5. Remove lower panel (a) Remove the 2 bolts. (b) Disengage the 3 clips and remove the lower Instrument panel finish panel. (c) Disconnect the connectors.

Unplug

6. Open switch blank cut-outs on sides as shown. File openings or use a Dremel tool Feed connectors through switch blank openings as required leaving enough slack in harness to connect switches. Plug harnesses together.

2

sPOD Installation Instructions 2005 – 2011 Toyota Tacoma www.4x4s-POD.com

5. Use this diagram for attaching harness to switches.

+

-

+

-

+

-

+

-

+

-

+

-

Note that the positive always connects to the SW and The negative connects to the GND Connect your accessories that correspond to the switch that activates it. These connections replace the switches, fuses & relays that came with your accessories.

3

sPOD Installation Instructions 2005 – 2011 Toyota Tacoma www.4x4s-POD.com

•

Connect Positive & Ground wire to battery terminals. Use supplied cable ties to secure all cables.

sx Auto Reset Circuit Breaker

1 1. Attach your accessories here. SWx Is the Positive and GND is the negative terminals. 2. Negative battery terminal. 3. Positive battery terminal. 4. Switch panel harness input. 5. Switch panel fuse. 6. Low voltage detection circuit. 7. Low voltage detection circuit fuse. Remove this fuse to disable LVCO • If the LVCO detects a low voltage (10.6VDC) and shuts the sPOD down, turn off all switches on sPOD and start the vehicle to enable the sPOD again. 8. Accessory fuses. Any fuse can go here up to 30 AMPs. (6 pl.) 9. Relays that are removable.

2 9

8 7

Always keep your engine running whenever possible when powering electrical accessories

3 6

5

4

After installation !!!Must start engine to activate system!!!

4