2009 – 2011 Toyota Corolla automatic transmission. 2009 – 2011 Toyota Matrix
automatic transmission. Conditions: The operator of the vehicle may complain ...
2009 Mazda 6 Equipped with Keyless Entry. Condition: The operator of the
vehicle may complain of a hard start condition. The technician may observe one
or ...
2008 Mazda Tribute ... noise coming from the right side of the engine near the
idler pulley. Cause: ... pulley by holding the probe to one of the idler pulley bolts.
Dixie Part Numbers: S-8738. Applications: 2005 – 2007 Toyota Corolla* up to
VIN indicated below. 2005 – 2007 Toyota Matrix (2WD)* up to VIN indicated
below.
2003 – 2004 Ford Expedition and. 2003 – 2004 Lincoln Navigator. Condition: ...
and the wiring harness replaced with the appropriate harness indicated in the.
2006 - 2008 Lexus RX 400h. 2006 – 2008 Toyota Highlander HV. 2008 Lexus
GS450h. 2008 Lexus LS 600h. 2008 Toyota Camry HV. 2008 Toyota Prius.
2007 Hyundai Entourage production range February 15, 2006 –. April 18, 2007.
Condition: The operator of the vehicle may complain of intermittent no crank.
2009 Mazda 6. Condition: The operator of the vehicle may complain that after
starting the vehicle the engine responded poorly. This may be due to the on
board ...
technicians of conditions that may exist or as a guide to aid in diagnosing and
servicing a vehicle. All references ... 1991 – 1995 Plymouth Voyager. With 2.2l or
...
2006 – 2009 Toyota Camry. 2006 – 2009 ... Multiple warning lights maybe
illuminated on the dash. • Accessories ... 90987-A2002 (Pink Colour). 90987-
02032 ...
We have your solution ... and the best part is it's conveniently located ... to send money to and you're ready to make t
The vehicle will warn drivers when diesel exhaust fluid is running low. Failure to
refill .... on Dodge Cummins 6.7L vehicles (4500 and 5500 chassis cabs) and ...
1999 – 2003 Ford Windstar Applications with 3.0 and 3.8L. Condition: The ...
connections be caused by loose fitting connections on the fuel pressure regulator
...
2007 Lexus ES350. 2007 – 2008 Lexus RX 350. 2007 – 2008 Toyota Tundra.
2008 Toyota Land Cruise. 2008 Toyota Sequoia. Condition: The operator of the ...
2003 Chrysler PT Cruiser 2.4L built prior to September 25, 2002. (MDH 0925XX)
... 2003 Chrysler Voyager 2.4L RG equipped vehicles built prior to. January 6 ...
2006/7 Honda FourTrax Rincon 680cc (ATV). (Rincon). ... In increments, brakes
let go and grabbed. **** T ..... Bobcat: Mini Bob S70 (wheeled loader) roll- cage ...
2008 – 2012 GMC Savana (G Series Van). 2008 – 2010 Saturn Vue. Condition:
The technician may observe diagnostic trouble code P0633 retained in the.
Applications: 2007 – 2010 Mazda CX-9 built before May 17, 2010. (VIN JM3 TB**
** A* 227576 and lower). Condition: The operator of the vehicle may complain ...
2007 – 2012 Chevrolet Avalanche1 ... 2008 – 2012 Chevrolet Silverado Hybrid ...
1 Note: With 6 speed transmission or Hybrid-Two Automatic Transmission (6L80
... of conditions that may exist or as a guide to aid in diagnosing and servicing a ...
2004 – 2007 Mazda RX-8. Condition: The operator of the vehicle may complain
of difficulty starting when the engine is turned off (or stalled) in cold temperatures
...
TBA. Applications: 2006 – 2008 Toyota RAV4. 2008 – 2011 Scion xB ...
Correction: Follow the manufacturer's recommended diagnostic and repair
procedures.
Applications: 2006 Lexus GS 300 with Smart Key system. 2006 – 2007 Lexus GS
430 with Smart Key system. 2006 – 2007 Lexus IS 250 with Smart Key system.
TECH TIPS Dixie Part Numbers:
A-80210 S-8730
A-80308 S-8772
A-80310 S-80393
A-80328 S-80402
Applications:
2006 Lexus GS 300 with Smart Key system 2006 – 2007 Lexus GS 430 with Smart Key system 2006 – 2007 Lexus IS 250 with Smart Key system 2006 – 2007 Lexus IS350 with Smart Key system 2007 Lexus ES 350 with Smart Key system 2007 Lexus GS 350 with Smart Key system 2007 Lexus LS 460 with Smart Key system
Condition: The vehicle may exhibit a no start condition after recharging a dead battery, using the vehicle to jump start another vehicle or after disconnecting the battery to perform service work.
Cause:
The steering lock electronic control module may need to be re-initialized.
Correction: The procedure below describes how to perform the re-initialization. • Ensure that the DCC fuse is installed (during shipping or prolonged storage this is removed to prevent parasitic drains). If the DCC fuse was not removed, remove it and reinstall it. • Place the shift lever in the “P” position (if not already done). • Open and close the driver’s side door. This activates the initialization process. • Depress the break pedal. • Press the “Start Stop” switch. • WARNING! The above process interrupts the power system and as such all other systems will also require re-initialization. Systems include (but are not limited to): • Power windows • Parking assistance features • Power doors • VGRS (steering) system
REV: 20100308 Removed A-80335 and added A-80308 REV: 20100308 Courtesy of APRA TSB_845.doc Dixie Tech Tips are intended for use by professional technicians, and are not for the general public. They are written to inform technicians of conditions that may exist or as a guide to aid in diagnosing and servicing a vehicle. All references to original equipment manufactures, vehicle manufactures and any other Trade Mark names are for the sole purpose of identifying the vehicle and or part that the Tech Tip applies to. This document is property of Dixie Electric Ltd. and is not to be copied or distributed with out written permission.
