2009 – 2011 Toyota Corolla automatic transmission. 2009 – 2011 Toyota Matrix
automatic transmission. Conditions: The operator of the vehicle may complain ...
2009 Mazda 6 Equipped with Keyless Entry. Condition: The operator of the
vehicle may complain of a hard start condition. The technician may observe one
or ...
2008 Mazda Tribute ... noise coming from the right side of the engine near the
idler pulley. Cause: ... pulley by holding the probe to one of the idler pulley bolts.
Dixie Part Numbers: S-8738. Applications: 2005 – 2007 Toyota Corolla* up to
VIN indicated below. 2005 – 2007 Toyota Matrix (2WD)* up to VIN indicated
below.
Applications: 2006 Lexus GS 300 with Smart Key system. 2006 – 2007 Lexus GS
430 with Smart Key system. 2006 – 2007 Lexus IS 250 with Smart Key system.
2003 – 2004 Ford Expedition and. 2003 – 2004 Lincoln Navigator. Condition: ...
and the wiring harness replaced with the appropriate harness indicated in the.
2006 - 2008 Lexus RX 400h. 2006 – 2008 Toyota Highlander HV. 2008 Lexus
GS450h. 2008 Lexus LS 600h. 2008 Toyota Camry HV. 2008 Toyota Prius.
2007 Hyundai Entourage production range February 15, 2006 –. April 18, 2007.
Condition: The operator of the vehicle may complain of intermittent no crank.
2009 Mazda 6. Condition: The operator of the vehicle may complain that after
starting the vehicle the engine responded poorly. This may be due to the on
board ...
technicians of conditions that may exist or as a guide to aid in diagnosing and
servicing a vehicle. All references ... 1991 – 1995 Plymouth Voyager. With 2.2l or
...
2006 – 2009 Toyota Camry. 2006 – 2009 ... Multiple warning lights maybe
illuminated on the dash. • Accessories ... 90987-A2002 (Pink Colour). 90987-
02032 ...
We have your solution ... and the best part is it's conveniently located ... to send money to and you're ready to make t
The vehicle will warn drivers when diesel exhaust fluid is running low. Failure to
refill .... on Dodge Cummins 6.7L vehicles (4500 and 5500 chassis cabs) and ...
2007 Lexus ES350. 2007 – 2008 Lexus RX 350. 2007 – 2008 Toyota Tundra.
2008 Toyota Land Cruise. 2008 Toyota Sequoia. Condition: The operator of the ...
2003 Chrysler PT Cruiser 2.4L built prior to September 25, 2002. (MDH 0925XX)
... 2003 Chrysler Voyager 2.4L RG equipped vehicles built prior to. January 6 ...
2006/7 Honda FourTrax Rincon 680cc (ATV). (Rincon). ... In increments, brakes
let go and grabbed. **** T ..... Bobcat: Mini Bob S70 (wheeled loader) roll- cage ...
2008 – 2012 GMC Savana (G Series Van). 2008 – 2010 Saturn Vue. Condition:
The technician may observe diagnostic trouble code P0633 retained in the.
Applications: 2007 – 2010 Mazda CX-9 built before May 17, 2010. (VIN JM3 TB**
** A* 227576 and lower). Condition: The operator of the vehicle may complain ...
2007 – 2012 Chevrolet Avalanche1 ... 2008 – 2012 Chevrolet Silverado Hybrid ...
1 Note: With 6 speed transmission or Hybrid-Two Automatic Transmission (6L80
... of conditions that may exist or as a guide to aid in diagnosing and servicing a ...
2004 – 2007 Mazda RX-8. Condition: The operator of the vehicle may complain
of difficulty starting when the engine is turned off (or stalled) in cold temperatures
...
TBA. Applications: 2006 – 2008 Toyota RAV4. 2008 – 2011 Scion xB ...
Correction: Follow the manufacturer's recommended diagnostic and repair
procedures.
1999 – 2003 Ford Windstar Applications with 3.0 and 3.8L. Condition: The ...
connections be caused by loose fitting connections on the fuel pressure regulator
...
TECH TIPS Dixie Part Numbers:
A-293
A-2075
Applications:
1999 – 2003 Ford Windstar Applications with 3.0 and 3.8L
Condition: The operator of the vehicle may comment that the alternator has recently been changed and the light comes on and/or the message screen shows “CHECK CHARGING SYSTEM”.
The technician may observe the diagnostic trouble codes P0171 and/or P0174 (system too lean). Cause:
On 3.8L applications the above conditions may be the result of loose connections be caused by loose fitting connections on the fuel pressure regulator vacuum line (at the intake manifold) and/or leaking isolator at the bolts or port gaskets. On all applications the Windstar Powertrain Control Module (PCM) and regulator function a little differently then most vehicles. A typical PCM type system works as a loop. The PCM tells the regulator what voltage to operate at, the regulator sends a signal back to the PCM showing what voltage it is operating at and then the PCM sends another signal if the output voltage is still not what the initial instruction was (for adjustment or to compensate for voltage drop on the wiring). The Windstar PCM only sends the signal once and then if the signal back is not what the PCM commanded the light and error messages come on.
REV: 20101214 Dixie Technical Department TSB_231.doc Dixie Tech Tips are intended for use by professional technicians, and are not for the general public. They are written to inform technicians of conditions that may exist or as a guide to aid in diagnosing and servicing a vehicle. All references to original equipment manufactures, vehicle manufactures and any other Trade Mark names are for the sole purpose of identifying the vehicle and or part that the Tech Tip applies to. This document is property of Dixie Electric Ltd. and is not to be copied or distributed with out written permission.
TECH TIPS In addition to this there is a capacitor to reduce interference on the ground of the alternator. The lead that goes between the alternator frame and the body frame is prone to fail from fatigue.
Correction: Ensure that if the alternator is not a Dixie product that the correct regulator has been used, many after market regulators do not work and OE has discontinued supplying regulators. Ensure that the capacitor lead has not deteriorated and broken. On all models ensure that the PCM has been calibrated to the latest revision (WDS B26.2 or later). This will be noted on a decal, typically located under the hood indicating that the PCM has been updated (similar to the one below).
On 1999-2001 3.8L applications inspect the vacuum line from the intake manifold to the fuel pressure regulator. If the vacuum line is loose, damaged or contaminated replace it (Ford part number XF2Z-9E498-DD). On 1999-2000 3.8L applications inspect the left-hand valve cover it should be Ford number 3F2Z-6582-BA. Install a new gasket if required following the manufacturer’s recommended procedures. REV: 20101214 Corrected Grammar and added the reference to A-2075
REV: 20101214 Dixie Technical Department TSB_231.doc Dixie Tech Tips are intended for use by professional technicians, and are not for the general public. They are written to inform technicians of conditions that may exist or as a guide to aid in diagnosing and servicing a vehicle. All references to original equipment manufactures, vehicle manufactures and any other Trade Mark names are for the sole purpose of identifying the vehicle and or part that the Tech Tip applies to. This document is property of Dixie Electric Ltd. and is not to be copied or distributed with out written permission.
